Tændingsmodul Altmann AMM-P3M8 enkelt carbureted M8 engines 17-26

4 623 DKK

Altmann single fire tændingsmodul
Læs mere

569449 Altmann
  • Fuldt justerbart og driftssikkert tændingsmodul til H-D-motorer
  • Kompatibelt med original krumtapsensor og tændspole
  • Ikke kompatibelt med original ledningsnet
  • Tre drejeknapper giver 4 indstillinger for maks. forstilling, tændingskurver og omdrejningsbegrænser (5750, 6000, 6250 og 6500 RPM)
  • Justeringer kan foretages med motoren slukket eller i gang, helt uden computer
  • Giver stabil tomgang ved 900 RPM eller helt ned til 350 RPM
  • Mål: 6x7x3 cm
  • Brugsanvisning medfølger

Perfekt ved konvertering fra indsprøjtning til karburator samt til alle trimningsgrader fra original og opefter. Mikuni HSR-karburatorer giver en meget trang montage mellem M8-topstykker, og Keihin-karburatorer passer ikke. Indsugningsmanifolde er fremstillet af forstærket polyamid og kræver passende støtte.

Passer til: Carbureted M8 engines 17-26

Kategori Ignition modules
Produkt-typ Ignition modules

AMM-P3M8 single fire ignition module

  • Compatible with stock crank sensor & coil
  • Three control knobs allow 4 settings for each range; maximum advance, advance curves and rev-limiter in 5750, 6000, 6250 and 6500 RPM
  • Not compatible with stock wiring harness
  • Used on H-D engines to install an advanced, fully adjustable and dependable ignition system
  • Super simple to set-up, easier than a points ignition!
  • Perfect for any stock to performance application and absolutely brilliant to get an engine running when converting from injection to carburetor
  • Adjustments can be done with engine off or running
  • Custom bikes require nothing else than the Atmann ignition, and the bike will run
  • No computer required
  • Suitable to provide best timing for maximum power for all engine capacities and tuning levels, including stock
  • Perfect idle at 900RPM or even at 350RPM, what ever your preference
  • Complete with instruction manual
  • Dimensions are 6x7x3cm, smaller than a pack of cigarettes
  • Note: Mikuni HSR carbs are a very tight fit between M8 heads, Keihin carbs will not fit
  • Note: Manifolds are made from reinforced polyamide and require adequate support

Fits: 17-26 carbureted M8 engines