Knaststøtteplade Feuling Flow billet Twin Cam 99-06
Feuling High Flow knaststøtteplade i fræset aluminium
Læs mere
- Fremstillet i 7075 fræset aluminium, som er 50 % hårdere og stærkere end original
- Matchede oliekanaler og forstørrede oliereservoirer øger oliestrømmen og volumen i motoren
- Øger oliestrømmen til løftere, stempelkølingsdyser, krumtapaksel og plejlstangslejer
- Sænker motortemperaturen med 25°–35° og olietemperaturen med 20°–30°
- Trykteste med overtryksventil indstillet til 55–60 psi
- Ekstra oliespor og trykfødehuller ved knasttappene for bedre smøring og mindre slid
- Til tandhjulsdrevne knastaksler (gear drive)
- Monteringsdele til lejer og holdeplade medfølger
Må kun bruges med Feuling oliepumpe (HP+ eller Race Series, art.nr. 566075), passer ikke til originalpumpe eller andre fabrikanters pumper. Giver op til 3 hk og 4 ft/lbs øget drejningsmoment på baghjulet i kombination med Feuling Race Series oliepumpe. Til Twin Cam 99–06 (undtagen 06 Dyna) med snævrere lejetolerancer for forbedret presspasning.
Passer til: Twin Cam 99-06
| Material | Aluminum |
| Färg | Red |
| Tillverkarens Art. Nr. | 8000 |
| Produkt-typ | Support Plate |
High Flow Camplate
- Camplate matches the oil portholes throughout the camplate to the port holes in the engine case increasing engine oil flow throughout the engine
- Camplates are pressure tested and pressure relief valve is seated, sealed and set to pop off at 55-60 psi
- Increase engine oil flow and volume by enlarging the oil pump reservoirs and critical oil passages
- 25°-35° cooler engine temperatures and 20°-30° cooler oil temperatures
- When matched with the Feuling Race Series oil pump rear wheel power gains of 3 horsepower and 4ft/lbs of torque can be achieved
- Added cam journal oil groove for cold start up protection and increased cam journal lubrication
- Oil pressure feed holes to front and back of cam journals to prevent excessive thrusting wear
- Bearing and retainer plate hardware is included
- Made in the USA
- For use only with Feuling oil pumps.
- For gear drive cams (incl
- Must be used with 566075 Feuling HP+ oil pump
- Enlarged oil pump reservoir, critical oil passages and precision matched oil port holes increase oil flow to lifters, piston cooling jets, crank shaft and connecting rod bearings
- Made from 7075 billet aluminum, which is 50% harder & stronger than the Factory cam support plate
- Will fit not stock or other manufacturers pumps
Camplates for '99-'06 Twin Cam (except 06 Dyna) have tighter cam bearing bore tolerances for improved press fit. Requires the use of '99-'06 style Feuling HP+ or Race Series oil pump. Not for '06 Dyna.
Fits: 99-06 Twin Cam (Excl. 2006 Dyna) with gear drive cams (NU)