Plade knastaksel Feuling Softail 07-17

4 146,9 DKK

Feuling High Flow støtteplade til knastaksel i fræset aluminium
Læs mere

09250110 Feuling
  • Fremstillet i 7075 fræset aluminium, 50 % hårdere og stærkere end original
  • Matcher oliekanalerne mod motorblokken for øget oliegennemstrømning i hele motoren
  • Forstørrede oliepumpereservoirer og kritiske passager øger oliegennemstrømning og -volumen
  • Trykprøvet med overtryksventil indstillet til 55-60 psi
  • Sænker motortemperaturen med 25°-35° og olietemperaturen med 20°-30°
  • Ekstra oliespor og trykfødehuller ved knastakslens lejesæder reducerer slid
  • Kompatibel med både kædedrift og knastaksler med tandhjulsdrift
  • Leveres med monteringsdele til leje og holdeplade

Må kun bruges med Feuling oliepumpe (passer ikke til original eller andre eftermarkedspumper). Kræver Feuling HP+ eller Race Series oliepumpe i 07-17-stil samt Feuling oliepumpe 566076. Dækplade kræves ved brug af knastaksler med tandhjulsdrift.

Passer til: Softail 07-17

Material Aluminum
Färg Red
Produkt-typ Support Plate
Tillverkarens Art. Nr. 8015

High Flow Camplate

  • Camplate matches the oil portholes throughout the camplate to the port holes in the engine case increasing engine oil flow throughout the engine
  • Camplates are pressure tested and pressure relief valve is seated, sealed and set to pop off at 55-60 psi
  • Increase engine oil flow and volume by enlarging the oil pump reservoirs and critical oil passages
  • 25°-35° cooler engine temperatures and 20°-30° cooler oil temperatures
  • When matched with the Feuling Race Series oil pump rear wheel power gains of 3 horsepower and 4ft/lbs of torque can be achieved
  • Added cam journal oil groove for cold start up protection and increased cam journal lubrication
  • Oil pressure feed holes to front and back of cam journals to prevent excessive thrusting wear
  • Bearing and retainer plate hardware is included
  • Made in the USA
  • For use only with Feuling oil pumps.
  • Compatible with chain & gear drive camshafts
  • Must be used with 566076 Feuling oil pump only
  • Enlarged oil pump reservoir, critical oil passages and precision matched oil port holes increase oil flow to lifters, piston cooling jets, crank shaft and connecting rod bearings
  • Made from 7075 billet aluminum, which is 50% harder & stronger than the Factory cam support plate
  • Will fit not stock or other manufacturers pumps

Camplates for '07-'17 Twin Cam ('06 Dyna included) have tighter cam journal tolerance for improved cam fitment. Block off plate is required when using gear drive cams. Requires the use of '07-'17 style Feuling HP+ or Race Series oil pump.

Fits: 07-17 Softail; 06-17 Dyna; 07-16 FLT/Touring (NU)