Tætningssæt ventilføring Kibblewhite KPMI PTFE Panhead 48-65 (4-pak)

138 DKK

Tætningssæt til ventilføring i PTFE fra Kibblewhite
Læs mere

09260792 Kibblewhite
  • Fremstillet i PTFE med tilsætningsstoffer for stabilitet og reduceret friktion
  • Bevarer sine mekaniske egenskaber ved temperaturer op til 500° F
  • Konstruktion med dobbelte fjedre giver konstant spænding mod ventilføring og ventilskaft
  • Kompatibel med ventilføringer i OEM-stil, kræver ingen bearbejdning
  • Tætningerne er cirka 0.020” (0.50mm) mindre end ventilskaftet og føringens top for tæt pasform
  • PTFE-materialet former sig efter anlægsfladerne efter montering
  • Til indsugning og udstødning
  • Fremstillet i USA

Til Shovelhead med 0.565" ventilføringer. Kræver særlig monteringsteknik: tryk ikke direkte på toppen af tætningen, men brug f.eks. en 12 mm 12-kantet topnøgle mod tætningens skulder, og brug gerne monteringsbeskyttelse i mylar over ventilskaftet.

Passer til: Panhead 48-65

Produkt-typ Seal
Material PTFE
Tillverkarens Art. Nr. 71002-4

Solid PC Valve Guide Seals

  • Manufactured from PTFE
  • PTFE is known to retain its mecahnical properties at temperatures as high as 500° F
  • Fillers have been added to keep the material stable and to reduce friction
  • Twin spring design provides continous tension on the valve guide and the stem of the valve
  • Made in the USA
  • KPMI, int/exh. valve guide seal kit. PTFE
  • Manufactured with PTFE lining
  • Kibblewhite Precision Machining valve guide seals are compatible with OEM style valve guides
  • No machining required
  • Installation note: Valve guides made of PTFE require another fitment technique than 'regular' or non-PTFE valve guides, this is due to the PTFE material
  • They are typically 0.020” (0.50mm) smaller than the valve stem and guide top they’re designed to fit
  • The guide top should have a decent chamfer
  • The valve stem should have a decent chamfer, but a mylar seal installation protector / installation capsule (501823 green 5/16" / 0.3125", 501824 Yellow 11/32" / 0.34375", 501825 3/8" / 0.375") is advised for easier installation over the valve stem
  • You have to kind of roll the seal around the valve tip while exerting downward pressure to get it started
  • Don't push directly on the very top of the seal to get it on to the guide, you’ll collapse the sealing area and tear the seal
  • A 12 point 12mm socket catches the shoulder of the guide pretty well and can be used to push the seal on to the guide until it just bottoms out
  • The choker wire around sealing area and the band around the area that fits the guide, combined with the hardness of the material itself makes the seal a tight fit and little harder to install than regular Viton seals
  • PTFE material does not have 'memory' and therefore is subject to creep
  • This creep allows the seal to conform to mating surfaces
  • Because of the ‘creep’ characteristic, the seal relaxes a bit after installation, and doesn’t drag on the valve stem as hard as it does during installation

For Shovelhead use with 0.565" guides.

Fits: 48-65 Panhead; 66-E79 Shovelhead (NU)