Tandhjul krumtaphusventilation S&S stål standard Big Twin L77-99 DS194242
Tandhjul til krumtaphusventilation i stål inklusive afstandsstykker fra S&S
Læs mere
- Tandhjul/ventil til krumtaphusventilation fremstillet i højkvalitetsstål i standardstørrelse (STD)
- Kan bruges som erstatning for original eller ved højtydende motorbyg
- Leveres som kit med tandhjul og afstandssæt i stål for korrekt aksialspil
- Forlængede ventilationshuller øger vakuummets varighed for bedre olieevakuering fra topstykkerne
- Fremstillet i USA
Kræver matchende knasttandhjul og pinion-tandhjul. For sene 77–84 Shovelhead og 84–99 Evo Big Twin blev timingen ændret i år 2000 for forbedret olieevakuering i motorer med stor cylindervolumen; den tidligere specifikation kan opnås ved at montere tandhjulet én tand med uret fra knasttandhjulets timingmærke. Fås også i .030" overstørrelse (art.nr. 531238) til slidte krumtaphuse.
Passer til: H-D 77-99
OEM-nr.: 25313-88B, 25313-77B, 25313-77, 25313-77A
| Produkt-typ | Breather valves |
| Kategori | after BDC. New opening is 17° |
Steel Breather Gear Kit
- Kit comes with gear and spacer
- Require the use of corresponding cam and pinion gear
- Made in the U.S.A.
- Steel breather valve & spacer set. STD
- With steel breather valve spacer set for correct end play
- High quality steel breather valve for use as stock or high performance replacement
- Note: S&S breather valves come with elongated breather holes to increase the duration of the vacuum, allowing more oil to be drawn from the cylinder heads
- This has no disadvantage in any model year, either stock or Big Inch motor
- Note: A .030" oversize breather is available to save worn or damaged crankcases as 531238
- A JIMS breather hole reamer (MCS 978343) will ream the damaged hole to +.030" so a +.030" breather can be used
- Tech tip: The timing for S&S breather valves, only for late 77-84 Shovel and 84-99 Evo Big Twin models, has been changed by S&S in the year 2000
- This is done to improve oil scavenging and reduce oil carry-over in high performance / large displacement engines
- Old opening was at TDC and closing at 65° after BDC
- The old timing specification can be obtained by installing the timing mark on the breather gear one tooth clockwise from the timing mark on the cam gear
- Also the breather's cavity oil evacuation hole (opposite of the drive gear), which used to be a round hole, has been elongated (made longer) to increase the duration of suction to the crankcase breather 'settling' cavity
- The new specifications are not useful in most stock engines, but harmless
- Breather windows in S&S cases will typically open at 7° after TDC and close 92° after BDC
- Builders using other crankcases may modify crankcase breather opening to obtain these specifications for maximum breather efficiency and performance
Fits: L77-99 Big Twin (NU) (Excl. TC)