Blinkersrelä Kellermann Load-Independent R1
Kellermann R1 lastoberoende blinkersrelä
Läs mer
- Lastoberoende med jämn blinktakt på 75 blinkningar per minut
- Fungerar med glödlampor, halogen, LED eller kombinationer av dessa
- Passar både 6V och 12V DC-system
- Brytande kapacitet: 0–50W vid 12V / 0–24W vid 6V
- Mycket kompakta mått: 22 x 12 x 6 mm (L x B x H) / 21 x 11 x 6 mm
- Har anslutning för blinkersindikator på instrumentpanelen
- ECE-godkänd
- Alla nödvändiga komponenter för montering ingår
Lämplig för alla motorcyklar med blinkersomkopplare och kan ersätta ursprungliga 2- eller 3-poliga blinkersreläer. Om byte till LED-blinkers gör att felaktiga blinkers också blinkar ansluts även indikatorklampan till R1-reläet för att åtgärda problemet. Rekommenderas inte för varningsblinkers.
| Produkt-typ | Flasher Relay |
| Tillverkarens Art. Nr. | 123,965 |
Load-Independent Flasher Relay R1
- Flasher Relay R1, Micro relay for the pros!
- The R 1 flasher relay has very small dimensions and flashes independently of load at a steady 75 pulses per minute.
- It also has a connection available for the flasher dashboard light. It is easily installed into the feed to the indicator switch, or can be swapped with the original 2-3 pole flasher relay.
- It is therefore suitable for all motorcycles with indicator switches. Should the change to LED indicators result in the non-intentionally activated indicators also flashing; then the indicator control light must also be connected to the R 1 relay. The ‘hazard warning’ effect will then be effectively.
- All necessary components required for installation are included.
- Load-independent / steady flash rate.
- Switching capacity 0-50W by 12V/ 0-24W by 6V.
- Very small dimensions 22 x12 x 6 mm (L/W/H).
- Suitable for indicator switches.
- Suitable for 6 and 12 volt DC applications.
- R1 turn signal flasher, ECE appr
- Very small with dimension just 21mm long x 11mm wide x 6mm high
- Load independant and will therefore flash 75 times a minute, no matter if incandescent bulbs, halogen, LED or a combination of these lights are used
- Note: Not advised to be used with hazard lights