Oliepumpe og knastplade Feuling Race Series oliekølet M8 17-26

9 867 DKK

Feuling Race Series kit med oliepumpe og knastplade
Læs mere

09251256 Feuling
  • Fremstillet i USA af hårdanodiseret 7075-aluminium, som er 50 % hårdere og stærkere end original
  • Øger olietryk, oliemængde, olieflow og retursug (scavenge)
  • 27 % større tandhjulsvolumen til tryk og retursug sammenlignet med original
  • 42 % mere retursugsvolumen og 68 % mere oliemængde til krumtapaksel og plejlstangslejer
  • Sænker motortemperaturen med 15°–25° og olietemperaturen med 15°–30°
  • Giver 10–30 psi højere olietryk og mindsker problemer med wet sumping og krumtaphusventilation
  • Bænktestet oliepumpe med overtryksventil tætnet til mindst 30 psi (2,06 bar) og fuld åbning ved 55–60 psi (3,79–4,13 bar)
  • Testresultater viser op til 2 hk og 2,71 Nm (2 ft/lbs) effektforøgelse på baghjulet på M-Eight

Overfyld ikke olietanken, Feuling anbefaler, at oliestanden holdes på 90–99 % ved varm motor. På M-Eight sidder opsugningsporten på højre side, hvilket gør, at tomgang eller opvarmning på sidestøtten fylder krumtaphuset og giver misvisende oliestand i tanken.

Passer til: M8. Oliekølede modeller 17-26

Färg Red
Tillverkarens Art. Nr. 7197
Produkt-typ Pump

Race Series Oil Pump/Camplate Kit

  • Increase oil pressure, oil volume, engine oil flow and return oil scavenging
  • Quieter and smoother engine operation
  • Engine temperatures run 15°-25° cooler
  • Oil temperatures run 15°-30° cooler
  • 10-30 lbs more psi of oil pressure
  • Reduces wet sumping, blow by and oily air cleaners
  • Test results show 2 horsepower gain and 2 ft/lbs of torque gain to the rear wheel on M-Eight
  • Includes a billet 7075 hard anodized oil pump which is 50% harder and stronger than the factory pump holding tighter tolerances under temperature (Race Series M-Eight oil pumps have deeper scavenge kidneys when compared to the HP+ kidneys for increased scavenge volume)
  • Includes FEULING High Flow billet camplate made from 7075 aluminum; which is 50% harder and stronger than the factory or FEULING OE+ camplates
  • Increases oil flow and volume by enlarging the oil pump reservoirs and critical oil passages, including matching the oil portholes throughout the camplate to the portholes in the engine case, which increases engine oil flow to the lifters, piston cooling jets, crankshaft and rod bearings
  • Oil pumps are bench-tested; the relief valve is seated and sealed to a minimum of 30 psi with full pop-off at 55-60 psi
  • Increased oil volume from the larger gears and properly sized passages along with the pressure relief valve seat and seal from these oil pumps is essential for proper oiling system function
  • FEULING oil pump and camplate combination eliminates common pressure and scavenge issues associated with the factory oiling systems
  • FEULING M-Eight oil pumps have the groove machined on the back cover to accept the factory crank bearing seal
  • Made in the USA
  • FEULING test results show as much as 50% reduction of engine sump oil level.
  • The M-Eight oil pick up port is on the right side of the engine. Letting the bike idle or warm up on the kickstand will naturally fill the engine case and skew the oil level in the tank.
  • EU: Test results show 2 horsepower gain and 2,71 Nm of torque gain to the rear wheel on M-Eight
  • EU: Oil pumps are bench-tested; the relief valve is seated and sealed to a minimum of 2,06 bar with full pop-off at 3,79 bar - 4,13 bar
  • OIL LEVEL NOTE
  • DO NOT OVERFILL OIL TANK It is important to get the correct hot oil level in your bike
  • Feuling recommends running the oil level 90%-99% full when hot
  • We recommend the following steps to achieve proper oil level: 1
  • Check cold oil level
  • Ride the bike until operating temperature is reached
  • Shut the bike off while still in the upright position. (This insures an accurate reading) 4
  • 5
  • Add or remove oil as needed

Has 27% more pressure and scavenge gear volume over stock, 42% more scavenge volume through port sizing, matched passages and holes to the engine case and 68% more oil volume to the crankshaft and connecting rod bearing.

Fits: 17-26 M8. Oil cooled models