Drev vevhusventilation S&S stål +.030 Big Twin 77-99
Drev för vevhusventilation i stål (+.030" OD) från S&S
Lue lisää
- Konstruktion helt i stål med insvetsat nät
- Överdimension: +.030" OD för att rädda slitna eller skadade vevhus
- Högre flöde än original och förlängt evakueringshål för ökat sug
- Ökad vakuumduration leder bort mer olja från topplocken
- Passar som ersättning för original eller högprestandamotorer
Stålventiler kräver distanser i stål, blanda inte delar av stål och plast. Brotschverktyg (+.030") från JIMS finns tillgängligt som 978343. S&S ändrade timingen för sena 77-99 Big Twin år 2000 för bättre oljereturgång i högprestandamotorer med stor cylindervolym, men den gamla specifikationen kan uppnås genom att montera märket en kugg medurs från kammens timingmärke.
Passar: H-D 77-99
| Material | Steel |
| Produkt-typ | Gear |
| Tillverkarens Art. Nr. | 33-4242 |
Steel Rotary Breather Gear
- All-steel construction
- Welded-in screen
- Higher flow than stock
- Elongated breather pocket scavenge hole for increased suction
- Steel breather valve. +.030" OD
- Used to save worn or damaged crankcases
- Okay for stock or high performance replacement
- Note: JIMS has a +.030" breather hole reamer tool which is available as 978343
- Note: that steel breathers require steel breather valve spacers
- Plastic breathers require plastic spacers
- Do not intermix steel and plastic parts
- Note: S&S breather valves come with elongated breather holes to increase the duration of the vacuum, allowing more oil to be drawn from the cylinder heads
- This has no disadvantage in any model year, either stock or Big Inch motor
- Tech tip: The timing for S&S breather valves, only for late 77-99 Big Twin models, has been changed by S&S in the year 2000
- This is done to improve oil scavenging and reduce oil carry-over in high performance / large displacement engines
- Old opening was at TDC and closing at 65° after BDC
- The old timing specification can be obtained by installing the timing mark on the breather gear one tooth clockwise from the timing mark on the cam gear
- Also the breather's cavity oil evacuation hole (opposite of the drive gear), which used to be a round hole, has been elongated (made longer) to increase the duration of suction to the crankcase breather 'settling' cavity
- The new specifications are not useful in most stock engines, but harmless
- Breather windows in S&S cases will typically open at 7° after TDC and close 92° after BDC
- Builders using other crankcases may modify crankcase breather opening to obtain these specifications for maximum breather efficiency and performance
Fits: L77-99 Big Twin (Excl. TC)