Oljepump Feuling Parts Camplate 17-19 Oilpump/cam H-D 17-upp
Feuling Race Series kit med oljepump och kamplatta
Läs mer
- Tillverkad i USA av hårdanodiserad 7075-aluminium som är 50 % hårdare och starkare än original
- Ökar oljetryck, oljevolym, oljeflöde och retursug (scavenge)
- 27 % större kuggvolym för tryck och retursug jämfört med original
- 42 % mer retursugsvolym och 68 % mer oljevolym till vevaxel och vevstakslager
- Sänker motortemperaturen med 15°–25° och oljetemperaturen med 15°–30°
- Ger 10–30 psi högre oljetryck och minskar problem med wet sumping och vevhusventilation
- Bänktestad oljepump med övertrycksventil tätad till minst 30 psi (2,06 bar) och full öppning vid 55–60 psi (3,79–4,13 bar)
- Testresultat visar upp till 2 hk och 2,71 Nm (2 ft/lbs) effektökning på bakhjulet på M-Eight
Överfyll inte oljetanken, Feuling rekommenderar att oljenivån hålls på 90–99 % vid varm motor. På M-Eight sitter uppsugningsporten på höger sida, vilket gör att tomgång eller varmkörning på sidostödet fyller vevhuset och ger missvisande oljenivå i tanken.
Passar: M8. Oljekylda modeller 17-26
| Färg | Red |
| Tillverkarens Art. Nr. | 7197 |
| Produkt-typ | Pump |
Race Series Oil Pump/Camplate Kit
- Increase oil pressure, oil volume, engine oil flow and return oil scavenging
- Quieter and smoother engine operation
- Engine temperatures run 15°-25° cooler
- Oil temperatures run 15°-30° cooler
- 10-30 lbs more psi of oil pressure
- Reduces wet sumping, blow by and oily air cleaners
- Test results show 2 horsepower gain and 2 ft/lbs of torque gain to the rear wheel on M-Eight
- Includes a billet 7075 hard anodized oil pump which is 50% harder and stronger than the factory pump holding tighter tolerances under temperature (Race Series M-Eight oil pumps have deeper scavenge kidneys when compared to the HP+ kidneys for increased scavenge volume)
- Includes FEULING High Flow billet camplate made from 7075 aluminum; which is 50% harder and stronger than the factory or FEULING OE+ camplates
- Increases oil flow and volume by enlarging the oil pump reservoirs and critical oil passages, including matching the oil portholes throughout the camplate to the portholes in the engine case, which increases engine oil flow to the lifters, piston cooling jets, crankshaft and rod bearings
- Oil pumps are bench-tested; the relief valve is seated and sealed to a minimum of 30 psi with full pop-off at 55-60 psi
- Increased oil volume from the larger gears and properly sized passages along with the pressure relief valve seat and seal from these oil pumps is essential for proper oiling system function
- FEULING oil pump and camplate combination eliminates common pressure and scavenge issues associated with the factory oiling systems
- FEULING M-Eight oil pumps have the groove machined on the back cover to accept the factory crank bearing seal
- Made in the USA
- FEULING test results show as much as 50% reduction of engine sump oil level.
- The M-Eight oil pick up port is on the right side of the engine. Letting the bike idle or warm up on the kickstand will naturally fill the engine case and skew the oil level in the tank.
- EU: Test results show 2 horsepower gain and 2,71 Nm of torque gain to the rear wheel on M-Eight
- EU: Oil pumps are bench-tested; the relief valve is seated and sealed to a minimum of 2,06 bar with full pop-off at 3,79 bar - 4,13 bar
- OIL LEVEL NOTE
- DO NOT OVERFILL OIL TANK It is important to get the correct hot oil level in your bike
- Feuling recommends running the oil level 90%-99% full when hot
- We recommend the following steps to achieve proper oil level: 1
- Check cold oil level
- Ride the bike until operating temperature is reached
- Shut the bike off while still in the upright position. (This insures an accurate reading) 4
- 5
- Add or remove oil as needed
Has 27% more pressure and scavenge gear volume over stock, 42% more scavenge volume through port sizing, matched passages and holes to the engine case and 68% more oil volume to the crankshaft and connecting rod bearing.
Fits: 17-26 M8. Oil cooled models